14core.com

14core.com

ideas become reality

Facebooktwitterrssyoutubeinstagramflickr

Menu

  • Home
  • Starters
    • Arduino Starters
    • Raspberry Pi
    • PIC Starters
    • Intel Starters
    • STM Starters
    • Texas Instruments Boards
    • BeagleBone
    • Google IOIO
    • Peripherals / Auxiliary
    • General Electronics
  • Going Advance
    • (IOT)Internet of Things
    • Robotics & Mechatronics
    • Atmel AVR
    • PIC Microchip
    • Indus­trial Automations
      • National Intruments
      • SCADA
      • PLC / RTU
    • FPGA
      • ALTERA
      • XILINX
    • Navigation
    • STM Series
  • Downloads
    • Drivers & Software
    • Diagrams & Pin-Out
    • Code Libraries
    • Image Byte Array C-Code Generator
  • Creative Lab
  • Contact Us
  • About Us

Atmel AVR


Wiring the CC1101 1GHz LSS Low Power, SPI interface, Spring Coil Transceiver

CC1101 is a low-cost sub 1GHz transceiver designed for low power wireless applications. The circuit is mainly used for Industrial, Scientific, and Medical (ISM) and Short Range Device (SRD) frequency bands running @ 315, 433, 868, and 915 MHz and

Wired Developer Atmel AVR, Communication, Going Advance, Modules, RX/TX Radio, STM Series 2 Comments Read more

Wiring the PCF8574AP 8bit Bidirectional IO Expander Driven i2C Communication Bus / SPI

This is the PCF8574AP consists of an 8-bit quasi-bidirectional port and an i2C Serial Bus Interface. The PCF8574AP has a low current consumption and includes latched output with HIGH consumption and include latched output with high current drive capability for

Wired Developer Atmel AVR, Communication, Going Advance, Peripherals / Auxiliary, The Starters No Comments Read more

Working on 24C256 EEPROM 256Kbit / 32 Kbyte Serial Memory Data Storage on i2C Bus

This is the AT24C256 that provides 32 Kbyte of serial, Electrically Erasable Programmable Read Only Memory (EEPROM) organized at 256Kbits WORDS of 8 BITS each. EEPROM can store data permanently unless you erase or write it and won’t lost the

Wired Developer Atmel AVR, Going Advance, STM Series 3 Comments Read more

Wiring a Stand Alone ATMEGA328P CMOS 8Bit Microcontroller

The ATMEGA328P is a CMOS 8Bit Microcontroller based on the AVR enhanced RISC architecture by executing powerful instructions in a single clock cycle. The ATMEGA328P achieves throughout put close to 1MIPS per MHz this empowers system designer to optimize the

Wired Developer Atmel AVR, Datasheets & Pin-Outs, Going Advance No Comments Read more

Working on Debounce / Interrupts on Switch with MCU

Switch are standard input to any electronic projects. Tactile switch works well in a PCB also can be used on a solderless breadboard. Switch are normally open or disconnected and when the push button is pressed are momentarily closed. Tactile

Wired Developer Arduino Starters, Atmel AVR, Communication, Sensors, The Starters No Comments Read more

Teensy Development Board Installation with Teensyduino

The Teensy CORTEX & AVR Development board is a complete USB base microcontroller development system. It uses a standard Mini-B USB, the Teennsy has a solder pads for all IO signals it is also available with the header pins to

Wired Developer Atmel AVR, Going Advance No Comments Read more

Wiring 2 or More I2C devices as Writer/Slave Receiver

In this illustration we will going to wire 2 or more Arduino board using i2c. Arduino board share information with each other on 2 wires CLS, and SCL.  below are the example how to used them and programmed to communicate

Wired Developer Atmel AVR, Communication, Going Advance No Comments Read more

Installing & Bootloading Micro Mini Pro ATMEGA32U4 5V 16MHz

I this illustration we will going to install and configure the newly Micro Mini Pro Microcontroller Board. This board can run as Leonardo bard or using boot load SF32U4 boards. Below are the steps how to install and configure using

Wired Developer Atmel AVR, Going Advance No Comments Read more

Wiring 8 Channel Optocoupler Relay Module

In this tutorial we will going to wire the 8 channel Relay Module driven by our own very owned microcontroller, the below illustration illustrate 8 device on external power source triggered by the relay. The 8 channel relay module has

Wired Developer Atmel AVR, Gear Head Motor, Home Automation, Micro DC Motor, Motors, PIC Microcontrollers, Raspberry Pi, STM Series, Texas Instruments Boards No Comments Read more

The DS1302 Real Time Clock on Arduino

Where going demonstrate how to use the DS1302 Real Time Clock with Arduino board, the DS1302 trickle-charge timekeeping chip contains a real-time clock and calendar and 31bytes of static RAM and its communicating with a microcontroller or microprocessor via a

Wired Developer Arduino Starters, Atmel AVR 5 Comments Read more

Burning & Programming the ATTiny 44 84 45 85 8 bit MCU

This guide we will going to burn / program the chip along with the Arduino IDE and hardware board, ATtine 25, 45 and 85 is a low power CMOS 8bit microcontroller base on the AVR enhanced RISC architecture by executing

Wired Developer Atmel AVR, Going Advance No Comments Read more

nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide

The I2C/TWI Communication shield module is mainly use and made for nRF24l01 transceiver module, dedicated to provide a reliable performance and to reduce the possibility of data lost in the communication process there are three stages to process a communicate

Wired Developer Atmel AVR, Communication, RX/TX Radio 2 Comments Read more
Page 1 of 212»

What’s new?

  • 14CORE E-Scooter External Lighting with ATTINY85 MCU, BMS 12v 3S, 18650, 12v LED, WS2812
  • Wiring SENSERION SCD30 CO2 Sensor in ESP32 TFT Display
  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor

Categories

  • Arduino Starters
  • Atmel AVR
  • BeagleBone
  • Bluetooth
  • Cellular Communication
  • Communication
  • Datasheets & Pin-Outs
  • Display
  • DSP Evaluation Boards
  • E Ink Module
  • Electricity & Current
  • Environment Sensor
  • Gear Head Motor
  • General Electronics
  • Going Advance
  • GPS Communication
  • Home Automation
  • Industrial
  • Infrared
  • Internet of Things
  • LabVIEW
  • LCD
  • LED
  • Liquid & Gas Sensors
  • MCU / MEMS / SOC
  • Medical & Health Sensors
  • Micro DC Motor
  • Modules
  • Motion Detections
  • Motors
  • Motors & Actuators
  • NXP Module / Boards
  • OLED
  • Peripherals / Auxiliary
  • Physical Monitor Sensors
  • PIC Microcontrollers
  • Positioning & Time Sensors
  • Power Management
  • Probes
  • Projects
  • Proximity Sensors
  • Raspberry Pi
  • RFID / NFC
  • Robotics & Mechatronics
  • RX/TX Radio
  • SCADA
  • Sensors
  • Servos
  • Stepper Motors
  • STM Series
  • TCP / IP Communication
  • Texas Instruments Boards
  • TFT LCD
  • The Starters
  • Thoughts
  • Touch Sensors
  • VFD

Recent

  • 14CORE E-Scooter External Lighting with ATTINY85 MCU, BMS 12v 3S, 18650, 12v LED, WS2812
  • Wiring SENSERION SCD30 CO2 Sensor in ESP32 TFT Display
  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
Facebooktwitterrssyoutubeinstagramflickr

Information

  • About Us
  • Contact Us
  • Terms & Conditions
  • Privacy Policy

Popular Searches

  • ESp8266
  • ATtiny85
  • HCMotor.h
  • esp32 cam
  • NEXTION
  • 433
  • esp32
  • can bus
  • mcp2515

#TAGS

Arduino Starters Atmel AVR Bluetooth Cellular Communication Communication Display Electricity & Current Environment Sensor Gear Head Motor General Electronics Going Advance GPS Communication Home Automation Industrial Infrared Internet of Things LCD LED Liquid & Gas Sensors MCU / MEMS / SOC Medical & Health Sensors Micro DC Motor Modules Motion Detections Motors Motors & Actuators OLED Peripherals / Auxiliary Physical Monitor Sensors Positioning & Time Sensors Probes Proximity Sensors Raspberry Pi Robotics & Mechatronics RX/TX Radio Sensors Servos Stepper Motors STM Series TCP / IP Communication Texas Instruments Boards TFT LCD The Starters Thoughts Touch Sensors

Makers

  • 14CORE E-Scooter External Lighting with ATTINY85 MCU, BMS 12v 3S, 18650, 12v LED, WS2812 | 14core.com on Working with SONY SPRESENSE Integration with Arduino IDE
  • Wiring SENSERION SCD30 CO2 Sensor in ESP32 TFT Display | 14core.com on Wiring the 128×64 1.3 inch OLED Display on 4 Wire, 3 Wire, i2C Interface
  • Eteru Nakuu on Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Sazki Muto on Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Park Jun on Build your own ESP8266 Web Server Tutorial
  • Wired Developer on Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Park Un on Build your Own Thermometer with ThingSpeak
  • Wired Developer on Wiring the PN532 (NFC) Near Field Communication Devices with Microcontroller

© 2022 - 14CORE | Are licensed under a Creative Commons Attribution Non-Commercial 3.0 License.


|
Designated trademarks and brands are the property of their respective owners. Your access or use of this website
constitutes acceptance of our | Terms & Conditions| and Copyright and Trademarks Policy.