14core.com

14core.com

ideas become reality

Facebooktwittergoogle_plusrssyoutubeinstagramflickr

Menu

  • Home
  • Starters
    • Arduino Starters
    • Raspberry Pi
    • PIC Starters
    • Intel Starters
    • STM Starters
    • Texas Instruments Boards
    • BeagleBone
    • Google IOIO
    • Peripherals / Auxiliary
    • General Electronics
  • Going Advance
    • (IOT)Internet of Things
    • Robotics & Mechatronics
    • Atmel AVR
    • PIC Microchip
    • Indus­trial Automations
      • National Intruments
      • SCADA
      • PLC / RTU
    • FPGA
      • ALTERA
      • XILINX
    • Navigation
    • STM Series
  • Downloads
    • Drivers & Software
    • Diagrams & Pin-Out
    • Code Libraries
    • Image Byte Array C-Code Generator
  • Creative Lab
  • Contact Us
  • About Us

LED


Wiring PCA9685 16-Channel/12Bit PWM i2C Bus Controller

This is the PCA9685 develop by XMP semiconductor. The PCA9685 is an i2C / TWI bus controller capable of driving 16 channels PWM controller. Suitable for driving servos and LED. Each LED output has its own 12-bit resolution at 4096

14core Editor Display, LED, Motors & Actuators, Servos No Comments Read more

Wiring 3014/3020/2835/5050/ Analog LED Strip with MCU

Wiring the analog LED Strip is not so difficult compare to addressable LED Strip. To control an analog LED Strip using popular Microcontroller like Arduino you need to add a power transistor to the circuit if you are new to

14core Editor Display, LED 1 Comment Read more

Wiring WS2812 8-Bit RGB LED Strip with Arduino

In this illustration we’re going to wire the 8bit WS2812B 50-50 which Chainable, addressable LED (Light Emitting Diode) A precise on any vivid colorful light mixing animation, these module as the example for this demonstration we going to control each

14core Editor Display, LED 4 Comments Read more

Wiring MAX7219 on 8 Bit 7 Segment Digital LED Tube Display

Yet another illustration guide, how to wire the MAX7219 on 8 Bit 7 Segment Digital LED Display driven by MAX7219. The MAX7219 is an integrated serial input output common-cathode display driver which is connected to microprocessor or microcontroller along with

14core Editor Display, LED No Comments Read more

Scanning i2C Device Address on Arduino

In this guide we will going to find and detect i2c address on our i2c device. You can scan and find the i2c address used by your devices by find the exact address used by the i2c device for more

14core Editor Arduino Starters, Communication, Display, LCD, LED, TFT LCD, The Starters 5 Comments Read more

Wiring the LCD 16×2 Keypad Shield on Arduino

In this illustration we will going to wire the 16X2 LCD Keypad Shield build for Arduino UNO, MEGA, Leonardo, this board has 4 bit Arduino LCD Library. The keypad shield has select left, up, down and right push button apart

14core Editor Arduino Starters, Display, LCD, LED, The Starters 2 Comments Read more

Wiring 3 Color RGB SMD Common Cathode LED

This is the SMD RGB LED Common Cathode Module, These module has 3 separate LEDs the Red, Green and Blue which can be individually driven by applying a voltage to the appropriate module pin this example code is uses the

14core Editor Arduino Starters, LED 1 Comment Read more

How to wire 8X8 Matrix LED with MAX7219 on Arduino

The 8×8 Matrix LED you can adjust brightness by using Arduino Sketch, the 8×8 LED has many applications in real life such as electronic display panel or signage display projects and display clock, etc. The LED matrix can be driven

14core Editor Display, LED 1 Comment Read more

Starter #17 Using RGB LED on Arduino

RGB(RED/GREEN/BLUE) LEDs Look just like a normal LED, however, inside of this LED has a 3 in 1 package, nside of the this LED it has Red, Green and Blue. This LED can be control using PWM(Pulse with Modulation) to

14core Editor Arduino Starters, Display, LED 1 Comment Read more

What’s new?

  • Wiring the VL53L1X Long-Range Proximity Sensor
  • Wiring the Sensirion SGP30 Multi-pixel Gas Sensor with ATMEGA328TQFP
  • Wiring the SENSIRION SDP31, SDP32, SDP36, SDP37 Pressure Sensor with ATMEGA328TQFP
  • Wiring the BOSCH BME680 GAS Detection, Temperature / Humidity & Pressure Sensor
  • Wiring MiCs 5524 / 6814 CMOS MEMS Gas Detection Sensor
  • Wiring Si1133 i2C Ultraviolet / Ambient Light sensor

Categories

  • Arduino Starters
  • Atmel AVR
  • BeagleBone
  • Bluetooth
  • Cellular Communication
  • Communication
  • Datasheets & Pin-Outs
  • Display
  • DSP Evaluation Boards
  • E Ink Module
  • Electricity & Current
  • Environment Sensor
  • Gear Head Motor
  • General Electronics
  • Going Advance
  • GPS Communication
  • Home Automation
  • Industrial
  • Infrared
  • Internet of Things
  • LabVIEW
  • LCD
  • LED
  • Liquid & Gas Sensors
  • MCU / MEMS / SOC
  • Medical & Health Sensors
  • Micro DC Motor
  • Modules
  • Motion Detections
  • Motors
  • Motors & Actuators
  • NXP Module / Boards
  • OLED
  • Peripherals / Auxiliary
  • Physical Monitor Sensors
  • PIC Microcontrollers
  • Positioning & Time Sensors
  • Power Management
  • Probes
  • Projects
  • Proximity Sensors
  • Raspberry Pi
  • RFID / NFC
  • Robotics & Mechatronics
  • RX/TX Radio
  • SCADA
  • Sensors
  • Servos
  • Stepper Motors
  • STM Series
  • TCP / IP Communication
  • Texas Instruments Boards
  • TFT LCD
  • The Starters
  • Thoughts
  • Touch Sensors
  • VFD

Recent

  • Wiring the VL53L1X Long-Range Proximity Sensor
  • Wiring the Sensirion SGP30 Multi-pixel Gas Sensor with ATMEGA328TQFP
  • Wiring the SENSIRION SDP31, SDP32, SDP36, SDP37 Pressure Sensor with ATMEGA328TQFP
  • Wiring the BOSCH BME680 GAS Detection, Temperature / Humidity & Pressure Sensor
  • Wiring MiCs 5524 / 6814 CMOS MEMS Gas Detection Sensor
  • Wiring Si1133 i2C Ultraviolet / Ambient Light sensor
Facebooktwittergoogle_plusrssyoutubeinstagramflickr

Information

  • About Us
  • Contact Us
  • Terms & Conditions
  • Privacy Policy

Popular Searches

  • esp8266
  • nodemcu
  • ESP32
  • arduino
  • attiny85
  • Two Color LED
  • 6 relay
  • nextion

#TAGS

Arduino Starters Atmel AVR Bluetooth Cellular Communication Communication Display Electricity & Current Environment Sensor Gear Head Motor General Electronics Going Advance GPS Communication Home Automation Industrial Infrared Internet of Things LCD LED Liquid & Gas Sensors Medical & Health Sensors Micro DC Motor Modules Motion Detections Motors Motors & Actuators OLED Peripherals / Auxiliary Physical Monitor Sensors PIC Microcontrollers Positioning & Time Sensors Probes Proximity Sensors Raspberry Pi Robotics & Mechatronics RX/TX Radio Sensors Servos Stepper Motors STM Series TCP / IP Communication Texas Instruments Boards TFT LCD The Starters Thoughts Touch Sensors

Makers

  • Alex on Wiring the i2C INA219 ZERO Drift, Bidirectional Current/Power Monitor with MCU
  • 14core Editor on Wiring & Programming ESP8266 12/12E / NodeMCU as WiFi Remote Client/Server Mode
  • Umer on Wiring & Programming ESP8266 12/12E / NodeMCU as WiFi Remote Client/Server Mode
  • 14core Editor on Free Open Source SCADA (Supervisory Control and Data Acquisition) for your SBC / MCU
  • 14core Editor on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Electrical Engineering on Free Open Source SCADA (Supervisory Control and Data Acquisition) for your SBC / MCU
  • Joseph Chrzempiec on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Electrical design on Free Open Source SCADA (Supervisory Control and Data Acquisition) for your SBC / MCU
© 2018 - 14CORE | Are licensed under a Creative Commons Attribution Non-Commercial 3.0 License.


|
Designated trademarks and brands are the property of their respective owners. Your access or use of this website
constitutes acceptance of our | Terms & Conditions| and Copyright and Trademarks Policy.




This website uses cookies for analytics, personalization, and other purposes. Click to learn more. By continuing to browse, you agree to our use of cookies as described in our Cookies Statement.OkPrivacy policy