In these illustration we will going to wire the Hall-Effect Switch in our Arduino board. Hall-effect switch are monolithic integrated circuit with tither magnetic specification, designed to operate continuously over temperature +150 degree Celsius and are more stable with both
Wiring 8 Channel Optocoupler Relay Module
In this tutorial we will going to wire the 8 channel Relay Module driven by our own very owned microcontroller, the below illustration illustrate 8 device on external power source triggered by the relay. The 8 channel relay module has
Didispark ATTiny85 with Ultrasonic HC SR04 Sensor
In this illustration we will going to wire the Digispark ATTiny Development Board with HC-SR04 Ultrasonic range detector, as our output we will going to use an RGB LED when the objects is near or closer to the sensor the
Installing Digispark Micro Size ATTiny Development Board
Digispark known as USB Development Board base on ATMEL Attiny85 microcontroller similar to Arduino Board line, the difference is smaller and limited pins, and a bit less powerful. Which a whole host of shields to extend its functionality and the
Wiring a Diode To Protect your Circuit
A diode is used mostly in the circuit so that the current will not flow in the reverse direction, a diode should be place in the circuit to allows the current to flow in one direction but not the other,
Wiring a Bi-Directional Voltage Converter 3.3 to 5v
The 2N700 is a N-Channel Enhance-Mode MOSFET used for low power switching applications. The 2N700 is widely available and popular part, often recomended as useful and common components. along with such other popular discrete semiconductors as the 1N4148 and 1N4001
Working on Shift Register 8 Bit Binary Counter
On this illustration we will going to drive and wire the 74HC595 on a shift register using our very own Arduino Board, The 74HC595 is high speed si-gate CMOS(Complementary Metal Oxide Semiconductor) integrated circuit device the pin is compatible with
How to Place/Connect a Pull Down Resistors on a Chip
A Pull-Down resistor is a resistor that makes the Pin of the chip will become normally LOW and it turn it going to HIGH when switched on. Pull-Up or Pull-Down resistor are mostly they are connected to the pins of
How to Place/Connect a Pull Up Resistors on Chip
A pull up resistor is a resistor that works the chip normally HIGH and change it to LOW when switched on, Pull-Up or Pull-Down resistor mostly they are connected to the pins of the chip so that they can define
Flashing LED FX Random light effect on PWM
Flashing like fire effect a flickering random light effect on 3 LED, using PWM (Pulse with Modulation), This project you cud plug it in DIY Buildings, Home, Cars, and Robots to have special FX Parts Required Arduino UNO/MEGA/NANO 1x RED
Mixing Color with 3 LED using Pulse with Modulation
In this tutorial we will going to mix the Red LED Green LED and Blue LED by adjusting the brightness on each LED using Pulse with Modulation capabilities of the ATMEGA chip. Parts Required Arduino UNO/MEGA/NANO 1x RED LED 1x
LED Running Light or Chasing Light Effect
On tutorial we will going to make a chasing LED, we will going to wire 10 LED to make an LED chase effect, similar to that used on the bikes and cars knight riders. Electronic parts required Arduino UNO/MEGA/MINI/NANO 10x