Another project that demonstrate how to build a low cost lake/pond water level logger sensor that can be deployed without an RF communication. however this project works as independent/standalone can be deployed on a remote area intended for science and
Motion Data Logging with RTC / PIR as Stand Alone
This project is intended for implementing a low cost proximity/motion data logger, useful device that can be used on environmental / animal scientific research for school/university studies. However the goal of this project is to build an open source that
FLIR Lepton PureThermal I/O Thermal Imaging Module
This the FLIR Thermal camera breakout module can easily integrate to your SBC Single Board computer kit / BSP boards or Microcontroller evaluation boards that driven by ARM, STM, TI, NXP, ATMEL, etc. This device can be used in thermal
Wiring Panasonic PaPIRs PIR Pyroelectric Motion Sensor
PIR (Passive Infrared or Pyroelectric) Motion Sensor from Panasonic has industrial grade, highly reliable and precise and accurate sensor. The Panasonic PIR motion sensor has three series that suit your requirements. The Panasonic EKMB (WL) has a low current consumption
Wiring LM393 as Steam, Water Vapor, Moisture Sensor
This is a steam sensor which is can sense a rain drops, steam or water vapor suitable of IOT project. The illustration below use LM3XX as differential comparators that drives the difference between the two inputs. The LM3XX device is
Wiring SenseAir LP8/S8 IR CO2 Sensor on TI CC3200 IOT-MCU
SenseAir Miniature (Carbon Dioxide) CO2 Sensor are non-dispersive small package infrared (NDIR) sensor, a new optical design that enable a precise and accurately measures carbon dioxide level up to 5% that runs on 30mA design for long-term battery or solar
Wiring SenseAir LP8/S8 CO2 Carbon Dioxide NDIR Sensor
These are the SenseAir Miniature (Carbon Dioxide) CO2 Sensor featuring a non-dispersive small package infrared (NDIR) sensor, a new optical design that enable a precise and accurately measures carbon dioxide level up to 5% that runs on 30mA design for
Wiring LuminOx O2 / Oxygen RS232 Optical Sensor
This is the LuminOx O2 (Oxygen) RS232 TTL driven sensor a high accuracy fluorescence based optical sensor series, design and develop by SST sensing. This device is capable of detecting and measuring ambient oxygen partial pressure PP02 level using the
MAXREFDES131# MAXIM Integrated Grid-Eye IR Array Sensor
This is the MAXREFDES131 an IR array sensing device solution module. This device is mainly driven by 2 components onboard, the Panasonic AMG8833 Grid-Eye and Maxim (DS28E17) a 1 wire-to-i2c master bridge and a dual channel addressable switch along with
TEMT6000 Visible Spectrum / Ambient Light Sensor
This is the TEMT6000 an Ambient Light Sensor which is sensitive to the visible spectrum. Capable of sensing a light brightness around you. The TEMT 6000 is a silicon NPN epitaxial phototransistor in a miniature transparent mold for surface mounting
MS5803-01BA i2C Pressure / Temperature Variometer Sensor
This is MEMS MS5803-01BA this device is a new generation of high resolution altimeter sensor which is integrated with serial peripheral interface (SPI) and i2C (two wire interface) bus interface. The MS5803-01BA-HE is a high endurance pad compare to MS580301BA
Wiring 2N7000 AN10441 as Logic Level Converter for i2C Protocol Devices
Other micro-controller uses 5v as standard input voltage, many latest device modules, popular sensors, GPS, RF modules, Flash Memories, SPI storage, Display, use 3 to 3.3v most of this devices requires logic level conversion to protect them from high voltage