Another illustration using PIR (Passive Infrared Sensor) with Numeric Pad and Arduino NANO, These project is based on Security System that’s detect human movement on the area and triggered the alarm. As you can see the diagram below it has
Wiring DIGISPARK ATTINY85 with 096″ OLED Display Screen
In this illustration we will going to wire the ATTINY85 to control the OLED Screen using i2C Bus on ATTINY85 Microcontroller, I will just give an introduction what is ATTNY85 Microcontroller. The ATTINY 25,45, and 85 is a low power
Wiring the MPU 6050 Sensor Mems Accelerometer GYRO
The MPU 6050 sensor board contains a MEMS ACCELEROMETER and MEMS GYRO a single chip that provide a very accurate data, as it contains 16bits analog to digital conversion hardware for each channel that captures the X, Y, and Z
Wiring a Metal Detector with NPN Proximity Sensor on Arduino
In this illustration we will going to wire the NPN Inductive Proximity Sensor to detect metal or any metal objects, this device also can be used as a metal detector screening when people walking through the entrance to find metal
Wiring Thermocouple MAX6675 on ESP8266 12E NodeMCU
In this illustration we will going to wire a Thermocouple, i2C OLED Screen and ESP8266 NodeMCU Board, as you can see the source code it is using a C Sketch code not a LUA script, if you don’t have ESP8266
Wiring DHT11, DHT22, with OLED Screen on ESP8266 12E
Yet another illustration how to use the 0.96” OLED 128×64 Screen Display, and DHTXX Temperature & Humidity Sensor, The OLED 128X64 Screen Display module it is made of 128×64 individual blue OLED pixels, each on is can be turn on
Wiring the E18-D80NK Infrared Distance Ranging Sensor
In this illustration we will going to wire the Infrared distance switch, a high-sensitive photoreflector to detect distance function, ranging from 3cm to 80cm. When the infrared emitted by the emitter it will get reflected on a surface blocked it
Wiring the GY-NEO6MV2 GPS on Arduino with LCD 16×2 Display
The NEO6 Module is a standalone GPS receiver in high performance UBOX 6 positioning engine. These flexible and cost effective receivers offer numerous connectivity option in small size 16×12.2 x 2.4mm package chip. Their compact architecture and power and memory
Wiring the MCP2515 Shield with OBD on Arduino
In this illustration we will going to wire the CAN BUS (Controller Area Network Bus) Shield with Arduino, if you don’t have any background how CAN (Controller Area Network Bus) works please refer this this link. As you can see
Wiring the SIM900A GSM/GPRS Development Board
In this illustration we are going to wire the SIM900A an ultra-compact and reliable wireless module. The SIM900A is a complete Dual-Band GSM/GPRS module in a SMT type device. These SIM900A delivers GSM/GPRS 900/1800MHz performance for voice, SMS, data, and
Wiring ESP8266 nodeMCU with HCSR04 Ultrasonic Sensor
In this illustration we will going to wire the ESP8266 12E nodeMCU with Ultrasonic Raging Sensor HCSR04. As you can see the illustration below the sensor trigger pin is connected to D1 which is pin 5 in Arduino Board, and
Wiring the Soil Moisture with Arduino
In this illustration we will going to wire the Moisture Sensor. These sensor can be used as a soil moisture to detect water level on the soil, if the soil moisture is depleted it will send a signal to HIGH.