This is the Freedom Development Platform from NXP Semiconductors, This has a set of software and hardware tools for evaluation and development. It is ideal for rapid prototyping of Microcontroller based applications and projects. The K28 board – FRDMK28F has
Wiring Flashing / Programming ESP-32 / ESP32S with USB – TTL / UART and Integration with Arduino IDE
ESP32S Wifi Bluetooth combo module is ultra performance that is high ultra low-power consumption Wi-Fi and Bluetooth wireless platform based on ESPRESSIF ESP32 chipset. ESP-32S dual-core 448 KByte ROM | 520 KByte SRAM | 16 KByte SRAM in RTC |
Write/Read Data to EEPROM – XC8 and PIC18F Microcontroller
There are three types of memories in a PIC Microcontroller, The Flash Program Memory, The Data Memory (RAM) and The EEPROM Data Memory. The code that is written by the user to perform a specific task by the MCU is
Wiring the MAX30100 Heart Rate Monitor with Arduino Microcontroller
This is the MAX300100 breakout board that reads heart rate or pulse oximetry. The chip has an integrated optical sensor that derives its reading from emitting two wavelength of light from the two LED’s then measures the absorbance of pulsing
Wiring a Stand Alone ATMEGA328P CMOS 8Bit Microcontroller
The ATMEGA328P is a CMOS 8Bit Microcontroller based on the AVR enhanced RISC architecture by executing powerful instructions in a single clock cycle. The ATMEGA328P achieves throughout put close to 1MIPS per MHz this empowers system designer to optimize the