Other micro-controller uses 5v as standard input voltage, many latest device modules, popular sensors, GPS, RF modules, Flash Memories, SPI storage, Display, use 3 to 3.3v most of this devices requires logic level conversion to protect them from high voltage
Wiring the Si70XX / i2C Inter-Integrated Circuit CMOS IC Temperature and Humidity Sensor
This is the Silicon Labs Si7021 i2C Humidity / Temperature Sensor. Si7021 is a monolithic CMOS IC that integrates humidity / temperature sensor elements this device has an analog to digital converter, signal processing, calibration data, and an i2C interface.
Wiring the MLX90614 Infrared Contactless Temperature Measurement Sensor on Microcontroller
This Is an Infrared thermometer a non-contact temperature measurement sensor develop by Melexis microelectronics integrated system, code name MLX90614. The MLX90614 has thermopile detector chip and the signal conditioning ASSP are integrated in a low noise amplifier, 17 bit ADS
Wiring The LIDAR (Light Detection and Ranging Sensor) Remote Sensing with Micro-controller
This is another illustration that demonstrate how to wire the LIDAR Sensor on your Microcontroller. LIDAR (Light Detection and Ranging) is a remote sensing device which is capable capture geographical information. LIDAR data is often collected by the survey of
Wiring DIGISPARK ATTINY85 with 096″ OLED Display Screen
In this illustration we will going to wire the ATTINY85 to control the OLED Screen using i2C Bus on ATTINY85 Microcontroller, I will just give an introduction what is ATTNY85 Microcontroller. The ATTINY 25,45, and 85 is a low power
Scanning i2C Device Address on Arduino
In this guide we will going to find and detect i2c address on our i2c device. You can scan and find the i2c address used by your devices by find the exact address used by the i2c device for more
nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
The I2C/TWI Communication shield module is mainly use and made for nRF24l01 transceiver module, dedicated to provide a reliable performance and to reduce the possibility of data lost in the communication process there are three stages to process a communicate