The BMP180 a successor of BMP085 a new generation of high precision, ultra-low power digital pressure sensor. The BMP180 is optimized for use in mobile devices, PDA, GPS navigation and outdoor equipment with a low altitude noise of merely 0.25m
Android LUX Meter with HC06 Bluetooth Module & Microcontroller
The BH1750 IC is a digital Ambient light sensor IC that drives on i2c / IIC bus interface. It is possible to detect wide range at high resolution rated to 1 – 65535 LUX. Mostly used in Mobile Phone, LCD
Wiring with TCRT5000 Reflective Optical Sensor Module on Raspberry Pi
This is the Line Tracking Sensor designed for line following robots. The board has two main components IR Transmitter and IR Receiver in one package named TCRT5000. The TCRT5000 are reflective sensors which include an infrared emitter and photo-transistor in
Wiring the DS18S20 1-Wire Temperature Sensor with Bluetooth HC06 on Android & Microcontroller
DS18B20 communication is using 1 wire port. With the 1wire port the memory and control functions will not be available before the ROM function protocol has been established. The master must first provide on of five ROM function command. 1.
Wiring Bluetooth HC06 in 8 Channel Relay with Android & Arduino Microcontroller
Another guide how to wire the HCo6 and 4 Channel Relay for switching, The HC06 modules uses BlueCore is a single chip radio and baseband IC for Bluetooth 2.4GHz system including enhance data rates (EDR) to 3Mbps. for more details
How MQTT Telemetry Transport Protocol Works for IOT Test with Mosquitto in Open GPIO Micro Computer
MQTT (Message Queuing Telemetry Transport) Protocol is a M2M (Machine to Machine) lightweight messaging protocol widely used in IOT (Internet of Things) that provides a resource constrained network clients. Almost IOT cloud platform support MQTT protocol to send and receive
Wiring Water Level, Rainfall, Leakage, Flood Meter Sensor with Arduino Microcontroller
Another illustration how to wire and build a simple water level, rainfall, leakage & water overflow detection. As you can see the first diagram below its uses a water sensor module which can be plug easily or build your own
Wiring the Electret Microphone Sensor Breakout Board
This is a breakout board of an Electret microphone, sound sensor. Which is essentially provide your Microcontroller an ear to detect or listen sound wave. This microphone has 100Hz-10kHz with an 60x mic preamplifier to amplify the sounds of voice,
Wiring the MPU9250 9 AXIS Motion Tracking Micro Electro Mechanical System
The MPU925 is a motion tracking device or MEMS (Micro Electro Mechanical System). A SIP (System in a Package) combining two components the MPU6500 & AK8963. The MPU6500 which is contains 3 axis gyroscope, 3 axis accelerometer, and onboard digital
Wiring Reed Switch Module with Arduino Microcontroller
On this illustration we will going to wire the Reed Switch Module. This module provides an analog as well as digital interface, as you can see on the board it has a potentiometer / trimmer used as a pull up
Wiring The Laser Transmitter on Photocell with Microcontroller
Another illustration how to build a simple physical intrusion detection with laser and photoresistor (or light-dependent resistor, LDR, or photocell). This guide shows how to wire and build a laser tripwire that triggers an alarm or output when the laser
Wiring the TCRT5000 Reflective Optical Sensor Module
This is the Line Tracking Sensor designed for line following robots. The board has two main components IR Transmitter and IR Receiver in one package named TCRT5000. The TCRT5000 are reflective sensors which include an infrared emitter and photo-transistor in