Communication

Scanning i2C Device Address on Arduino

In this guide we will going to find and detect i2c address on our i2c device. You can scan and find the i2c address used by your devices by find the exact address used by the i2c device for more

Bluetooth Home Automation with Arduino and Android

In this illustration we will going to wire the HC-04,HC-05 or HC-06 module using serial communication with our Arduino board and 4 channel relay, we will going to control the relay on the Android smart phone or tablet via Bluetooth

Gas Detection MQ-2 Sensor with Arduino

In this illustration we will wire the GAS SENSOR MQ2 Module, these device is very useful for GAS leakage detection in home or industry it can detect H2, LPG, CH4, CO, Alcohol or Propane. This device is very sensitive and

Wiring ESP8266 WiFi Transceiver on Arduino with Relay

In this illustration we will going to wire the ESP8266 Module on Arduino but before we can proceed we need to setup the ESP8266 module using AT-COMMAND please refer to this link. As you can see the illustration below our

Wiring the Infrared Emission Sensor Module on Arduino

In this illustration we will going to wire the Infrared Transmitter. The infrared transmitter are now common in our house, offices, even in our cars and other places, etc., It is based on wireless sensing, but also can be more

Wiring the Infrared Receiver for Universal Remote Control

In this illustration we will going to wire the NEC IR 38K Infrared Remote Control, The NEC IR 38K is an universal infrared control, encoding format mainly for cars, home appliances, lighting design equipment, digital photo frame, and other device

Wiring the Analog Temperature Sensor

In this illustration we will going to wire the analog base temperature sensor module, this module is based on thermistor, a NTC Thermistor with a Multi-point temperature measurement to -55 Degree Celsius up to +125 Degree Celsius and has accuracy

Wiring and Configure the ESP8266 using AT Command on Arduino

In this illustration we will going to wire and test using AT COMMAND on the ESP8266 with Arduino TTL UART to do this steps we need to remove the ATMEGA328 chip to accurately test the ESP8266 module. The AT Command

Wiring and Flashing the ESP8266 Firmware via TTL UART Bridge

The ESP8266 module has a preprogrammed firmware which support the serial interface communication by controlling using AT commands. The ESP8266 chip was develop by ESPRESSIF System, a smart connectivity platform or ESCP that provides high performance, high integration wireless SOCs,