14core.com

14core.com

ideas become reality

Facebooktwitterrssyoutubeinstagramflickr

Menu

  • Home
  • Starters
    • Arduino Starters
    • Raspberry Pi
    • PIC Starters
    • Intel Starters
    • STM Starters
    • Texas Instruments Boards
    • BeagleBone
    • Google IOIO
    • Peripherals / Auxiliary
    • General Electronics
  • Going Advance
    • (IOT)Internet of Things
    • Robotics & Mechatronics
    • Atmel AVR
    • PIC Microchip
    • Indus­trial Automations
      • National Intruments
      • SCADA
      • PLC / RTU
    • FPGA
      • ALTERA
      • XILINX
    • Navigation
    • STM Series
  • Downloads
    • Drivers & Software
    • Diagrams & Pin-Out
    • Code Libraries
    • Image Byte Array C-Code Generator
  • Creative Lab
  • Contact Us
  • About Us

Arduino


Working with SONY SPRESENSE Integration with Arduino IDE

The SONY Spresense is designed for IOT development it is a compact development board base on CXD5602 multicore microcontroller (ARM CORTEX M4F x 6 cores) with a clock speed of 156 MHz, allows you to develop an IOT application that

Wired Developer Communication, GPS Communication, MCU / MEMS / SOC, The Starters 6 Comments Read more

14CORE Mini Sumo Robot with Multi-senors on Arduino Microcontroller

This is the 14CORE Mini sumobot driven by Arduino Microcontroller. this bot is programmed automatically find its opponents and automatically push the opponent out of the black circle, however this robots are equipped with sensors programmed to search and look

Wired Developer Gear Head Motor, Micro DC Motor, Motors, Motors & Actuators, Robotics & Mechatronics, Sensors, Stepper Motors 4 Comments Read more

Wiring the Nondispersive Infrared MH-Z14 Carbon Dioxide, Gas Sensor on Microcontroller

This is an MHZ14 NDIR Infrared Gas sensor, design specialize to detect an existence of Carbon Dioxide (C02) in air and non-oxygen defendant.  This sensor has a non-dispersive infrared or NDIR principle design in a tight integration of infrared absorbing

Wired Developer Environment Sensor, Sensors, Thoughts No Comments Read more

Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller

This is another illustration how to wire the HT621 driven 6 Digit 7 Segment LCD Display on Microcontroller. This module is widely used in multi-meter, voltage monitor, solar power monitor, clock, thermometer, electronic measuring device, automotive, etc. this module is

Wired Developer Display, LCD 9 Comments Read more

Wiring the Diffused Reflection Laser Sensor with Microcontroller

This is a diffused reflection laser sensor that has an integrated IR transmitter and a receiver. This sensor using light that transmit by the Laser and receive by the Infrared since the laser adopts modulation processing technology, the receiving tube

Wired Developer Motion Detections, Proximity Sensors, Sensors, STM Series No Comments Read more

Wiring the TLS2591 High Range LUX / LIGHT Intensity / Ambient Light Sensor on Microcontroller

TLS2591 is high sensitive light to digital converter that transform light intensity into digital signal output that has integrated i2C interface on chip. The TLS2591 combines one infrared-responding photodiode on a single CMOS integrated circuit that has two integrating ADC

Wired Developer Environment Sensor, Positioning & Time Sensors, Proximity Sensors, Sensors No Comments Read more

Wiring the MAX30100 Heart Rate Monitor with Arduino Microcontroller

This is the MAX300100 breakout board that reads heart rate or pulse oximetry. The chip has an integrated optical sensor that derives its reading from emitting two wavelength of light from the two LED’s then measures the absorbance of pulsing

Wired Developer Medical & Health Sensors, Physical Monitor Sensors, Sensors, Touch Sensors 5 Comments Read more

Wiring a Stand Alone ATMEGA328P CMOS 8Bit Microcontroller

The ATMEGA328P is a CMOS 8Bit Microcontroller based on the AVR enhanced RISC architecture by executing powerful instructions in a single clock cycle. The ATMEGA328P achieves throughout put close to 1MIPS per MHz this empowers system designer to optimize the

Wired Developer Atmel AVR, Datasheets & Pin-Outs, Going Advance No Comments Read more

14CORE Line Following BOT with TCRT5000/L298N on Microcontroller

This is the 14CORE Design Line Following robot which is capable of detecting lines and follow it. This robot uses TCRT5000 Sensor which is capable of emitting dark color lines. The TCRT5000 are reflective sensors which include an infrared emitter

Wired Developer Gear Head Motor, Motors, Motors & Actuators, Positioning & Time Sensors, Robotics & Mechatronics, Sensors, Stepper Motors 3 Comments Read more

Wiring the i2C BMP180 Barometric Pressure Sensor with Microcontroller

The BMP180 a successor of BMP085 a new generation of high precision, ultra-low power digital pressure sensor.  The BMP180 is optimized for use in mobile devices, PDA, GPS navigation and outdoor equipment with a low altitude noise of merely 0.25m

Wired Developer Environment Sensor, Sensors No Comments Read more

Wiring the Bluetooth HC06 / 4 Channel Relay Switching with Android

Another guide how to wire the HCo6 and 4 Channel Relay for switching,  The HC06 modules uses BlueCore is a single chip radio and baseband IC for Bluetooth 2.4GHz system including enhance data rates (EDR) to 3Mbps. for more details

Wired Developer Bluetooth, Communication, Home Automation, Robotics & Mechatronics, RX/TX Radio 10 Comments Read more

Wiring the MCP2515 Stand-alone CAN Controller with SPI

This is an illustration how CAN (Controller Area Network) protocol interface works with Microcontroller. CAN protocol is methodology of communication between electronics devices, commonly found in Automotive, these device is the responsible for the car engine management system, Gear Control,

Wired Developer Communication, Datasheets & Pin-Outs No Comments Read more
Page 1 of 512345»

What’s new?

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer

Categories

  • Arduino Starters
  • Atmel AVR
  • BeagleBone
  • Bluetooth
  • Cellular Communication
  • Communication
  • Datasheets & Pin-Outs
  • Display
  • DSP Evaluation Boards
  • E Ink Module
  • Electricity & Current
  • Environment Sensor
  • Gear Head Motor
  • General Electronics
  • Going Advance
  • GPS Communication
  • Home Automation
  • Industrial
  • Infrared
  • Internet of Things
  • LabVIEW
  • LCD
  • LED
  • Liquid & Gas Sensors
  • MCU / MEMS / SOC
  • Medical & Health Sensors
  • Micro DC Motor
  • Modules
  • Motion Detections
  • Motors
  • Motors & Actuators
  • NXP Module / Boards
  • OLED
  • Peripherals / Auxiliary
  • Physical Monitor Sensors
  • PIC Microcontrollers
  • Positioning & Time Sensors
  • Power Management
  • Probes
  • Projects
  • Proximity Sensors
  • Raspberry Pi
  • RFID / NFC
  • Robotics & Mechatronics
  • RX/TX Radio
  • SCADA
  • Sensors
  • Servos
  • Stepper Motors
  • STM Series
  • TCP / IP Communication
  • Texas Instruments Boards
  • TFT LCD
  • The Starters
  • Thoughts
  • Touch Sensors
  • VFD

Recent

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer
Facebooktwitterrssyoutubeinstagramflickr

Information

  • About Us
  • Contact Us
  • Terms & Conditions
  • Privacy Policy

Popular Searches

  • attiny85
  • ESP8266
  • ESP32
  • Arduino
  • nextion
  • CAN
  • Digispark
  • oled
  • HCMotor.h

#TAGS

Arduino Starters Atmel AVR Bluetooth Cellular Communication Communication Display Electricity & Current Environment Sensor Gear Head Motor General Electronics Going Advance GPS Communication Home Automation Industrial Infrared Internet of Things LCD LED Liquid & Gas Sensors Medical & Health Sensors Micro DC Motor Modules Motion Detections Motors Motors & Actuators OLED Peripherals / Auxiliary Physical Monitor Sensors PIC Microcontrollers Positioning & Time Sensors Probes Proximity Sensors Raspberry Pi Robotics & Mechatronics RX/TX Radio Sensors Servos Stepper Motors STM Series TCP / IP Communication Texas Instruments Boards TFT LCD The Starters Thoughts Touch Sensors

Makers

  • Wired Developer on Wiring the GY-NEO6MV2 GPS on Arduino with LCD 16×2 Display
  • thom on Wiring the GY-NEO6MV2 GPS on Arduino with LCD 16×2 Display
  • thom on Wiring the GY-NEO6MV2 GPS on Arduino with LCD 16×2 Display
  • rog on Wiring the MPU9250 9 AXIS Motion Tracking Micro Electro Mechanical System
  • Amir Hossein on Wiring the UBLOX NEO-6X / NEO-7X GNSS/GPS Module
  • Nikita on Wiring the Passive & Active Buzzer with Raspberry Pi
  • Nikita on Wiring the Passive & Active Buzzer with Raspberry Pi
  • Jack Wilborn on Working on Allegro ACS758 AC or DC Current Sensor

© 2020 - 14CORE | Are licensed under a Creative Commons Attribution Non-Commercial 3.0 License.


|
Designated trademarks and brands are the property of their respective owners. Your access or use of this website
constitutes acceptance of our | Terms & Conditions| and Copyright and Trademarks Policy.




Important Cookie Information :

We use cookie to provide you the best possible experience, this site uses cookies and by continuing to use the site you agree that we can save them on your device. Cookies are small text files which are placed on your computer and which remember your preference / some details of your visit. Our cookies don’t collect any personal information. For information, please read our Privacy Statement & Cookie Policy, which also explains how to disable this option in your browser. Find out more.