Arduino Starters

On tutorial we will going to make a chasing LED, we will going to wire 10 LED to make an LED chase effect, similar to that used on the bikes and cars knight riders. Electronic parts required Arduino UNO/MEGA/MINI/NANO 10x LED 10x 220 Ohms Resistors Jumper wires Solder-less Breadboard Wiring ...

In this tutorial we will making a traffic lights that will change from green to red via amber, after a set of time using the 4 state system. This project could be used on model railway, model road or model car, make a set of working traffic light for your ...

Where going demonstrate how to use the DS1302 Real Time Clock with Arduino board, the DS1302 trickle-charge timekeeping chip contains a real-time clock and calendar and 31bytes of static RAM and its communicating with a microcontroller or microprocessor via a simple serial interface. The DS1302 real time clock and calendar ...

In this guide we will going to make a simple Earth Quake monitoring device and learn how to connect and control the digital shock/vibration sensor module, we will going use the LED as our triggered output instead using alarm or any special output devices. When the sensor detects a vibration ...

The VCC, VSS, VDD, and VEE notation are use in naming the voltage at various common voltage power supply terminal only a wire that point between exist power source of specified circuit. It change these general voltage terms map to transistor technology. This terminology originated in some way from the ...

A water flow sensor is a plastic valve body with rotor that provides a hall-effect sensing when water flows through the motor. The motor will roll and the speed will change on a different rate flow. The hall-effect sensor will read the corresponding voltage pulse signal and send the signal ...

In recent years automatic identification procedure have become very popular in many service industries, manufacturing companies, purchasing and distribution logistics, and material flow systems. Automatic identification procedures provide information on people, animals, goods, products, transportation's, the most common form of electronic data-carrying devices are the smart card based upon a ...

In this tutorial you will going to learn how to control and drive the DC Motor on Arduino, you will also learn how to used the analog output PWM or Pulse with Modulation to control the speed of the motor by changing the value of 0 ~ 255 from the ...

Sometimes you will encounter an errors wile your in the Arduino IDE, some error sometimes it very difficult to fix like java applet errors some error are easy to fix. below are the list of error while your doing you sketch project in Arduino IDE. However as a beginners you ...

These tutorial  will guide you to make  a password access control using "Keypad Membrane" connected to a Relay Module, Were just temporarily used LED for the output just to check if it is working, instead using a mechanical solenoid door lock. Here is the guide using a Relay module in ...

These keypad it is the same like computer keyboard, but rather the pressure pads that have only outline symbol printed on a flat, flexible surface. These membrane keyboard, which work by electrical contact between the key surface under layer circuit when key areas are press. See below the diagram of ...

RGB(RED/GREEN/BLUE) LEDs Look just like a normal LED, however, inside of this LED has a 3 in 1 package, nside of the this LED it has Red, Green and Blue. This LED can be control using PWM(Pulse with Modulation) to be able to adjust the color brightness or mixing and ...