In this illustration we’re going to wire the 8bit WS2812B 50-50 which Chainable, addressable LED (Light Emitting Diode) A precise on any vivid colorful light mixing animation, these module as the example for this demonstration we going to control each
In this illustration we will going to wire the 128×64 OLED display screen, using SPI and I2C. As you can see the diagram below we used the Pin 5 to Pin 8 in Arduino Microcontroller to wire our OLED Display
Another illustration that demonstrate how to use the ESP8266 as a web-based Soil Moisture / Temperature and Humidity Monitor. If you’re new to ESP8266 please refer to this link. There are 3 main component are used to this project. The
This is a wireless remote controlled robot using ESP8266 with L298N or L293D H-Bridge Motor Controller along with your Arduino Microcontroller, This bot is also tested in ESP8266 7, 12, 12E with or without Microcontroller. As you can see the
This is the Line Tracking Sensor designed for line following robots. The board has two main components IR Transmitter and IR Receiver in one package named TCRT5000. The TCRT5000 are reflective sensors which include an infrared emitter and photo-transistor in
IR Light reflection switch, useful for obstacle avoidance or line following, for obstacle avoidance you can place this module in front of the sender /receive diodes that will cause the out pin to be pulled low at distance of 1cm.
Another illustration how to control and wire the Rolling Ball Tilt Switch or Ball Sensor along with Raspberry Pi. Ball tilt switch allows you to detect an location or inclination they are small and easy to wired-up it use low
This is a breakout board of an Electret microphone, sound sensor. Which is essentially provide your Microcontroller an ear to detect or listen sound wave. This microphone has 100Hz-10kHz with an 60x mic preamplifier to amplify the sounds of voice,
This is the 14CORE sensor set for Arduino, Raspberry, AVR, STM, Bagelbone, and BananaPi also compatible to most popular IOT modules like ESP8266 and LinkOne. These kit consists of 37 individual modules which can be used to carry out many
In this illustration we will going to wire the HC05 XBEE like Bluetooth Module, This Bluetooth module adapt the XBEE design compact communication, it has the pinout that compatible with the XBEE shields all kinds of microcontroller system, who uses
Image to Array Generator for 0.96” 128×64 OLED Display Module. Support Windows Only. Download | Zip | Exe | Rar Byte to Array Generator for UTFT IPS LCD Screen 480×320 Shield. Support Windows Only. Support on DM-TFT18-101, DM-TFT22-102, DM-TFT24-104, DM-TFT28-103,
On this illustration we will going to wire the Ethernet Shield W5100, This shield allows an Arduino Board to connect to the internet. This shield is based on W5100 WIZNET Chip, a network stack capable of both TCP and UDP.