14core.com

14core.com

ideas become reality

Facebooktwitterrssyoutubeinstagramflickr

Menu

  • Home
  • Starters
    • Arduino Starters
    • Raspberry Pi
    • PIC Starters
    • Intel Starters
    • STM Starters
    • Texas Instruments Boards
    • BeagleBone
    • Google IOIO
    • Peripherals / Auxiliary
    • General Electronics
  • Going Advance
    • (IOT)Internet of Things
    • Robotics & Mechatronics
    • Atmel AVR
    • PIC Microchip
    • Indus­trial Automations
      • National Intruments
      • SCADA
      • PLC / RTU
    • FPGA
      • ALTERA
      • XILINX
    • Navigation
    • STM Series
  • Downloads
    • Drivers & Software
    • Diagrams & Pin-Out
    • Code Libraries
    • Image Byte Array C-Code Generator
  • Creative Lab
  • Contact Us
  • About Us

Wiring The AX1838HS / VS1838 / NEC-IR 38K IR on Raspberry Pi

Another illustration demonstrating how IR Emission works on Raspberry Pi, for introduction how IR Emission works please refer to this link. IR (Infrared Receiver) is a device / component which receives IR signals and can independently receive IR rays and

Wired Developer Communication, Infrared, Raspberry Pi, The Starters 1 Comment Read more

Wiring Push Button with RPI Driven by C-Code and Python

Push buttons are simple switch mechanism for controlling some aspect of a machine or a process. Buttons are typically made out of plastics, metal, carbons or rubber. The surface is usually flat or shaped to accommodate the human finger or

Wired Developer Raspberry Pi, Sensors, The Starters No Comments Read more

Wiring The 3144 Hall Effect Sensor with Raspberry Pi

Linear Sensor are critical to the performance to their sensitivity and linearity over their specified operating temperature range and immune to most environmental disturbance that may affect optical or mechanical devices, such as vibration, moisture, dirt or oil films, ambient,

Wired Developer Sensors 1 Comment Read more

Wiring The Vibration Tilt Switch / Ball Tilt Switch with RPI

Another illustration how to control and wire the Rolling Ball Tilt Switch or Ball Sensor along with Raspberry Pi. Ball tilt switch allows you to detect an location or inclination they are small and easy to wired-up it use low

Wired Developer Motion Detections, Positioning & Time Sensors, Raspberry Pi, Sensors No Comments Read more

Wiring the MCP2515 Stand-alone CAN Controller with SPI

This is an illustration how CAN (Controller Area Network) protocol interface works with Microcontroller. CAN protocol is methodology of communication between electronics devices, commonly found in Automotive, these device is the responsible for the car engine management system, Gear Control,

Wired Developer Communication, Datasheets & Pin-Outs No Comments Read more

Wiring the DS18B20 Digital Thermometer w/d Raspberry Pi

The DS18B20 is a digital thermometer provides 9bit to 12bit Celsius temperature measurement, this device has an alarm function with nonvolatile that user can program upper and lower trigger points. DS18B20 communicates over one wire bus or one data line

Wired Developer Raspberry Pi, Sensors, The Starters 1 Comment Read more

Driving the QD320DB16NT9481RA 3.2 TFT 480×320 LCD ILI9481 w/d MEGA2560

This is the 3.2 inch TFT LCD with 262K color on 480×320 Resolution. The QD320DB16NT9481RA shield support 16 wire data bus interface, working voltage at 3.3v ~ 5v power conversion and level conversion circuit. This shield can be directly inserted

Wired Developer Display, LCD, TFT LCD No Comments Read more

Wiring the Metal Touch Sensor Module with MCU

This is the metal touch sensor module. This sensor is an electronic switching device. Basically, it will operate when touched by a charged any part of the body it triggers a high frequency which is generated by the transistor that

Wired Developer Sensors, Touch Sensors No Comments Read more

Wiring the Electret Microphone Sensor Breakout Board

This is a breakout board of an Electret microphone, sound sensor. Which is essentially provide your Microcontroller an ear to detect or listen sound wave. This microphone has 100Hz-10kHz with an 60x mic preamplifier to amplify the sounds of voice,

Wired Developer Environment Sensor, Sensors No Comments Read more

Wiring the 14CORE 37 Sensors for Arduino & Raspberry Pi

This is the 14CORE sensor set for Arduino, Raspberry, AVR, STM, Bagelbone, and BananaPi also compatible to most popular IOT modules like ESP8266 and LinkOne. These kit consists of 37 individual modules which can be used to carry out many

Wired Developer Raspberry Pi, Sensors Read more

Wiring the XS3868 / OVC3860 Stereo Bluetooth 2.0 +EDR Module Board

The OVC3860 is a low power single chip Bluetooth RF transceiver baseband processor for Bluetooth stereo solutions. The OVC3860 is a 2.4GHz RF transceiver, Bluetooth v2 + EDR (Enhanced Data Rate) baseband, can transfer high quality 20bit stereo audio CODEC

Wired Developer Bluetooth, Communication 1 Comment Read more

Wiring the BH1750 Digital 16bit Serial Output Type Ambient Light Sensor

The digital 16bit serial output type Ambient Light sensor IC develop by ROHM semiconductor. The BH1750 IC is a digital Ambient light sensor IC that drives on i2c / IIC bus interface. This IC is the most suitable to obtain

Wired Developer Environment Sensor, Sensors No Comments Read more
Page 13 of 30« First«...9101112131415161718...30...»Last »

What’s new?

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer

Categories

  • Arduino Starters
  • Atmel AVR
  • BeagleBone
  • Bluetooth
  • Cellular Communication
  • Communication
  • Datasheets & Pin-Outs
  • Display
  • DSP Evaluation Boards
  • E Ink Module
  • Electricity & Current
  • Environment Sensor
  • Gear Head Motor
  • General Electronics
  • Going Advance
  • GPS Communication
  • Home Automation
  • Industrial
  • Infrared
  • Internet of Things
  • LabVIEW
  • LCD
  • LED
  • Liquid & Gas Sensors
  • MCU / MEMS / SOC
  • Medical & Health Sensors
  • Micro DC Motor
  • Modules
  • Motion Detections
  • Motors
  • Motors & Actuators
  • NXP Module / Boards
  • OLED
  • Peripherals / Auxiliary
  • Physical Monitor Sensors
  • PIC Microcontrollers
  • Positioning & Time Sensors
  • Power Management
  • Probes
  • Projects
  • Proximity Sensors
  • Raspberry Pi
  • RFID / NFC
  • Robotics & Mechatronics
  • RX/TX Radio
  • SCADA
  • Sensors
  • Servos
  • Stepper Motors
  • STM Series
  • TCP / IP Communication
  • Texas Instruments Boards
  • TFT LCD
  • The Starters
  • Thoughts
  • Touch Sensors
  • VFD

Recent

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer
Facebooktwitterrssyoutubeinstagramflickr

Information

  • About Us
  • Contact Us
  • Terms & Conditions
  • Privacy Policy

Popular Searches

  • esp32
  • attiny85
  • ESP8266
  • Digispark
  • arduino
  • oled
  • CAN
  • nextion
  • index

#TAGS

Arduino Starters Atmel AVR Bluetooth Cellular Communication Communication Display Electricity & Current Environment Sensor Gear Head Motor General Electronics Going Advance GPS Communication Home Automation Industrial Infrared Internet of Things LCD LED Liquid & Gas Sensors Medical & Health Sensors Micro DC Motor Modules Motion Detections Motors Motors & Actuators OLED Peripherals / Auxiliary Physical Monitor Sensors PIC Microcontrollers Positioning & Time Sensors Probes Proximity Sensors Raspberry Pi Robotics & Mechatronics RX/TX Radio Sensors Servos Stepper Motors STM Series TCP / IP Communication Texas Instruments Boards TFT LCD The Starters Thoughts Touch Sensors

Makers

  • Wired Developer on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Wired Developer on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Darchen on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Hichem on Wiring NodeMCU ESP8266 12E with i2C 16×2 LCD Screen
  • Robert on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring and Flashing ESP32-WROVER, ESP WROOM 32 with USB TTL UART and ESP32 Download Tool
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring Flashing / Programming ESP-32 / ESP32S with USB – TTL / UART and Integration with Arduino IDE
  • Art on Wiring the DS18S20 1-Wire Temperature Sensor with Bluetooth HC06 on Android & Microcontroller

© 2020 - 14CORE | Are licensed under a Creative Commons Attribution Non-Commercial 3.0 License.


|
Designated trademarks and brands are the property of their respective owners. Your access or use of this website
constitutes acceptance of our | Terms & Conditions| and Copyright and Trademarks Policy.




Important Cookie Information :

We use cookie to provide you the best possible experience, this site uses cookies and by continuing to use the site you agree that we can save them on your device. Cookies are small text files which are placed on your computer and which remember your preference / some details of your visit. Our cookies don’t collect any personal information. For information, please read our Privacy Statement & Cookie Policy, which also explains how to disable this option in your browser. Find out more.