14core.com

14core.com

ideas become reality

Facebooktwitterrssyoutubeinstagramflickr

Menu

  • Home
  • Starters
    • Arduino Starters
    • Raspberry Pi
    • PIC Starters
    • Intel Starters
    • STM Starters
    • Texas Instruments Boards
    • BeagleBone
    • Google IOIO
    • Peripherals / Auxiliary
    • General Electronics
  • Going Advance
    • (IOT)Internet of Things
    • Robotics & Mechatronics
    • Atmel AVR
    • PIC Microchip
    • Indus­trial Automations
      • National Intruments
      • SCADA
      • PLC / RTU
    • FPGA
      • ALTERA
      • XILINX
    • Navigation
    • STM Series
  • Downloads
    • Drivers & Software
    • Diagrams & Pin-Out
    • Code Libraries
    • Image Byte Array C-Code Generator
  • Creative Lab
  • Contact Us
  • About Us

Environment Sensor


Wiring DHT11, DHT22, with OLED Screen on ESP8266 12E

Yet another illustration how to use the 0.96” OLED 128×64 Screen Display, and DHTXX Temperature & Humidity Sensor, The OLED 128X64 Screen Display module it is made of 128×64 individual blue OLED pixels, each on is can be turn on

Wired Developer Display, Environment Sensor, Home Automation, OLED, Sensors 9 Comments Read more

Wiring the SIM900A GSM/GPRS Development Board

In this illustration we are going to wire the SIM900A an ultra-compact and reliable wireless module. The SIM900A is a complete Dual-Band GSM/GPRS module in a SMT type device. These SIM900A delivers GSM/GPRS 900/1800MHz performance for voice, SMS, data, and

Wired Developer Cellular Communication, Communication, Environment Sensor, Home Automation, Liquid & Gas Sensors, Sensors No Comments Read more

Wiring the Soil Moisture with Arduino

In this illustration we will going to wire the Moisture Sensor. These sensor can be used as a soil moisture to detect water level on the soil, if the soil moisture is depleted it will send a signal to HIGH.

Wired Developer Arduino Starters, Environment Sensor, Sensors, The Starters 1 Comment Read more

Wiring The DS18B20 1-Wire Temperature Sensor

In this illustration we will going to wire the DS18B20 single wire temperature sensor. The digital DS18B20 Sensor provide fairly good accuracy and range of connection. The wire length can be reach up to 100m. The DS18B20 has four main

Wired Developer Arduino Starters, Environment Sensor, Sensors, The Starters No Comments Read more

Wiring the 3 AXIS Digital Compass Magnetometer HMC5883L

In this illustration we will going to wire the HMC5883 III AXIS Magnetometer, this module is capable of sensing 3 directions. It’s communicate with the HMC5883L Chip onI2c interface with on-board logic level converter. The HMC588L is using 3.3 or

Wired Developer Environment Sensor, Robotics & Mechatronics, Sensors No Comments Read more

Gas Detection MQ-2 Sensor with Arduino

In this illustration we will wire the GAS SENSOR MQ2 Module, these device is very useful for GAS leakage detection in home or industry it can detect H2, LPG, CH4, CO, Alcohol or Propane. This device is very sensitive and

Wired Developer Arduino Starters, Environment Sensor, Liquid & Gas Sensors, Modules, Sensors, The Starters No Comments Read more

Wiring the Analog Temperature Sensor

In this illustration we will going to wire the analog base temperature sensor module, this module is based on thermistor, a NTC Thermistor with a Multi-point temperature measurement to -55 Degree Celsius up to +125 Degree Celsius and has accuracy

Wired Developer Arduino Starters, Environment Sensor, Home Automation, Internet of Things, Physical Monitor Sensors, Sensors, The Starters No Comments Read more

Wiring the DS3231 IIC Precision Real Time Clock Module

In this illustration we will going to wire the MAXIM DS3231 Real Time IC Clock. This module can be used in almost any project that requires a real time clock and date. The pins are already installed so that you

Wired Developer Environment Sensor, Home Automation, Proximity Sensors No Comments Read more

Wiring Hall Effect Sensor Switch Magnet Detector Module

In these illustration we will going to wire the Hall-Effect Switch in our Arduino board. Hall-effect switch are monolithic integrated circuit with tither magnetic specification, designed to operate continuously over temperature +150 degree Celsius and are more stable with both

Wired Developer Environment Sensor, Sensors No Comments Read more

Simple Earthquake Detection Sensor with Vibration Module

In this guide we will going to make a simple Earth Quake monitoring device and learn how to connect and control the digital shock/vibration sensor module, we will going use the LED as our triggered output instead using alarm or

Wired Developer Arduino Starters, Environment Sensor, Motion Detections, Sensors, The Starters 2 Comments Read more

Working on Dust Particle Optical Sensor with Arduino

Sharp’s GP2Y1010U0F is an optical air quality sensor it was designed to sense dust particles. An infrared emitting diode and a photo-transistor are diagonally arrange into this device, to allow it to detect the reflected light of dust in the

Wired Developer Environment Sensor, Medical & Health Sensors, Sensors No Comments Read more

Temperature & Humidity Sensor With Arduino Using DHT11/DHT22

This project will guide you how to use DHT11/DHT22 Humidity & Temperature Sensor to interconnected with Arduino, The DHTXX sensors are very popular in Arduino module component. The DHT sensors are relative cheap sensors for measuring temperature and humidity. These

Wired Developer Arduino Starters, Environment Sensor, The Starters 1 Comment Read more
Page 6 of 6«123456

What’s new?

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer

Categories

  • Arduino Starters
  • Atmel AVR
  • BeagleBone
  • Bluetooth
  • Cellular Communication
  • Communication
  • Datasheets & Pin-Outs
  • Display
  • DSP Evaluation Boards
  • E Ink Module
  • Electricity & Current
  • Environment Sensor
  • Gear Head Motor
  • General Electronics
  • Going Advance
  • GPS Communication
  • Home Automation
  • Industrial
  • Infrared
  • Internet of Things
  • LabVIEW
  • LCD
  • LED
  • Liquid & Gas Sensors
  • MCU / MEMS / SOC
  • Medical & Health Sensors
  • Micro DC Motor
  • Modules
  • Motion Detections
  • Motors
  • Motors & Actuators
  • NXP Module / Boards
  • OLED
  • Peripherals / Auxiliary
  • Physical Monitor Sensors
  • PIC Microcontrollers
  • Positioning & Time Sensors
  • Power Management
  • Probes
  • Projects
  • Proximity Sensors
  • Raspberry Pi
  • RFID / NFC
  • Robotics & Mechatronics
  • RX/TX Radio
  • SCADA
  • Sensors
  • Servos
  • Stepper Motors
  • STM Series
  • TCP / IP Communication
  • Texas Instruments Boards
  • TFT LCD
  • The Starters
  • Thoughts
  • Touch Sensors
  • VFD

Recent

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer
Facebooktwitterrssyoutubeinstagramflickr

Information

  • About Us
  • Contact Us
  • Terms & Conditions
  • Privacy Policy

Popular Searches

  • attiny85
  • esp32
  • esp8266
  • Digispark
  • arduino
  • OLED
  • CAN
  • nextion
  • index

#TAGS

Arduino Starters Atmel AVR Bluetooth Cellular Communication Communication Display Electricity & Current Environment Sensor Gear Head Motor General Electronics Going Advance GPS Communication Home Automation Industrial Infrared Internet of Things LCD LED Liquid & Gas Sensors Medical & Health Sensors Micro DC Motor Modules Motion Detections Motors Motors & Actuators OLED Peripherals / Auxiliary Physical Monitor Sensors PIC Microcontrollers Positioning & Time Sensors Probes Proximity Sensors Raspberry Pi Robotics & Mechatronics RX/TX Radio Sensors Servos Stepper Motors STM Series TCP / IP Communication Texas Instruments Boards TFT LCD The Starters Thoughts Touch Sensors

Makers

  • Wired Developer on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Wired Developer on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Darchen on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Hichem on Wiring NodeMCU ESP8266 12E with i2C 16×2 LCD Screen
  • Robert on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring and Flashing ESP32-WROVER, ESP WROOM 32 with USB TTL UART and ESP32 Download Tool
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring Flashing / Programming ESP-32 / ESP32S with USB – TTL / UART and Integration with Arduino IDE
  • Art on Wiring the DS18S20 1-Wire Temperature Sensor with Bluetooth HC06 on Android & Microcontroller

© 2020 - 14CORE | Are licensed under a Creative Commons Attribution Non-Commercial 3.0 License.


|
Designated trademarks and brands are the property of their respective owners. Your access or use of this website
constitutes acceptance of our | Terms & Conditions| and Copyright and Trademarks Policy.




Important Cookie Information :

We use cookie to provide you the best possible experience, this site uses cookies and by continuing to use the site you agree that we can save them on your device. Cookies are small text files which are placed on your computer and which remember your preference / some details of your visit. Our cookies don’t collect any personal information. For information, please read our Privacy Statement & Cookie Policy, which also explains how to disable this option in your browser. Find out more.