14core.com

14core.com

ideas become reality

Facebooktwitterrssyoutubeinstagramflickr

Menu

  • Home
  • Starters
    • Arduino Starters
    • Raspberry Pi
    • PIC Starters
    • Intel Starters
    • STM Starters
    • Texas Instruments Boards
    • BeagleBone
    • Google IOIO
    • Peripherals / Auxiliary
    • General Electronics
  • Going Advance
    • (IOT)Internet of Things
    • Robotics & Mechatronics
    • Atmel AVR
    • PIC Microchip
    • Indus­trial Automations
      • National Intruments
      • SCADA
      • PLC / RTU
    • FPGA
      • ALTERA
      • XILINX
    • Navigation
    • STM Series
  • Downloads
    • Drivers & Software
    • Diagrams & Pin-Out
    • Code Libraries
    • Image Byte Array C-Code Generator
  • Creative Lab
  • Contact Us
  • About Us

Robotics & Mechatronics


Wiring & Data Reading with SD Card Module

In this illustration we will going to wire the Arduino SD Card Module along with Arduino UNO and MEGA 2560 microcontroller board. We will going to transfer a data from standard SD card to our PC vise-versa. As you can

Wired Developer Arduino Starters, Internet of Things, Robotics & Mechatronics, The Starters No Comments Read more

Wiring the NRF24L01 2.4GHz Radio as Remote Switching

In this illustration we will going to wire the Arduino Board to build a remote switching using the NORDIC NRF24l01 2.4GHz Transceiver. The NRF24l01 will act as a remote controller to other NRF24L01. Both the master and the slave will

Wired Developer Communication, Home Automation, Robotics & Mechatronics, RX/TX Radio 6 Comments Read more

Wiring the solenoid with TIP120 Transistor To Higher Load

In this illustration we will going to drive the solenoid with the input voltage of 12v to 24v using TIP120 Transistor. Because Arduino can only support power output of 3.3 and 5v this is not enough to work with the

Wired Developer Going Advance, Motors & Actuators, Robotics & Mechatronics No Comments Read more

Wiring the Line finder Sensor with Arduino

In this illustration we will going to wire the Line Finder Sensor Module HCARDUXXXX5. This module requires only DIO pin defined as an input) to work. When the sensor detects a dark line it will trigger the signal into HIGH,

Wired Developer Robotics & Mechatronics No Comments Read more

Wiring the Obstacle Avoidance Sensor Module Board

Another illustration that very useful building an obstacle bot or a project that used obstacle avoidance. This module allows for sensing of solid objects within a fixed range it is actually an adjustable with on-board potentiometer. This guide is guide

Wired Developer Robotics & Mechatronics No Comments Read more

Wiring the TCS320 / TCS230 Color Detection with Arduino

This illustration we will going to wire the TCS230/TCS3200 chip module board this boards is designed to detect the colors, it has an array of photodiode 8×8 matrix. These photodiodes are covered with four type of filters. The TCS230/TCS320 converts

Wired Developer Robotics & Mechatronics, Sensors, The Starters 1 Comment Read more

Wiring MOSFET module board on Higher Loads with Motor

In this illustration we will going to wire the IRF520 MOSFET (Metal Oxide Semiconductor Field-effect Transistor) Module Board a simple breakout board for driving higher loads. MOSFET enables you to control higher voltage projects on microcontroller. MOSFET is also kind

Wired Developer Arduino Starters, Gear Head Motor, Internet of Things, Micro DC Motor, Motors, Robotics & Mechatronics, Servos, Stepper Motors 2 Comments Read more

Wiring L293D UNO/MEGA Shield with Stepper Motor

The L293D is a dedicated module to fit in Arduino UNO R3 Board, and Arduino MEGA, It is actually a motor driver shield that has full featured Arduino Shield can be used to drive 2 to 6 DC motor and

Wired Developer Gear Head Motor, Micro DC Motor, Motors, Motors & Actuators, Robotics & Mechatronics, Servos, Stepper Motors 2 Comments Read more

Controlling the L293D UNO/MEGA Shield with DC Motors

The L293D is a dedicated module to fit in Arduino UNO R3 Board, and Arduino MEGA, It is actually a motor driver shield that has full featured Arduino Shield can be used to drive 2 to 6 DC motor and

Wired Developer Gear Head Motor, Micro DC Motor, Motors, Motors & Actuators, Robotics & Mechatronics, Servos, Stepper Motors 6 Comments Read more

Using L298n H Bridge with Stepper Motors on Arduino

The L298 Dubai H Bridge is base on l298 Chip manufacture by ST Semiconductor. The l298 is an integrated monolithic circuit in a 15 lead multi-watt and power S020 package. It is a high voltage and high current full dual

Wired Developer Motors, Motors & Actuators, Robotics & Mechatronics, Stepper Motors 1 Comment Read more

Wiring & Driving the L298n H Bridge with 2 to 4 DC Motors

The L298  H Bridge is base on l298 Chip manufacture by ST Semiconductor. The l298 is an integrated monolithic circuit in a 15 lead multi-watt and power S020 package. It is a high voltage and high current full dual bridge

Wired Developer Gear Head Motor, Motors, Motors & Actuators, Robotics & Mechatronics 5 Comments Read more

Wiring MOSFET to Arduino and Driving Bigger Loads

Each one of Arduino Pins can be used to power devices that use up to 20 mA, this is a very small amount of current to drive, just enough to run an LED. If you try working to drive something

Wired Developer Atmel AVR, Gear Head Motor, Going Advance, Motors & Actuators, Robotics & Mechatronics, Stepper Motors No Comments Read more
Page 4 of 5«12345»

What’s new?

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer

Categories

  • Arduino Starters
  • Atmel AVR
  • BeagleBone
  • Bluetooth
  • Cellular Communication
  • Communication
  • Datasheets & Pin-Outs
  • Display
  • DSP Evaluation Boards
  • E Ink Module
  • Electricity & Current
  • Environment Sensor
  • Gear Head Motor
  • General Electronics
  • Going Advance
  • GPS Communication
  • Home Automation
  • Industrial
  • Infrared
  • Internet of Things
  • LabVIEW
  • LCD
  • LED
  • Liquid & Gas Sensors
  • MCU / MEMS / SOC
  • Medical & Health Sensors
  • Micro DC Motor
  • Modules
  • Motion Detections
  • Motors
  • Motors & Actuators
  • NXP Module / Boards
  • OLED
  • Peripherals / Auxiliary
  • Physical Monitor Sensors
  • PIC Microcontrollers
  • Positioning & Time Sensors
  • Power Management
  • Probes
  • Projects
  • Proximity Sensors
  • Raspberry Pi
  • RFID / NFC
  • Robotics & Mechatronics
  • RX/TX Radio
  • SCADA
  • Sensors
  • Servos
  • Stepper Motors
  • STM Series
  • TCP / IP Communication
  • Texas Instruments Boards
  • TFT LCD
  • The Starters
  • Thoughts
  • Touch Sensors
  • VFD

Recent

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer
Facebooktwitterrssyoutubeinstagramflickr

Information

  • About Us
  • Contact Us
  • Terms & Conditions
  • Privacy Policy

Popular Searches

  • ESP32
  • attiny85
  • esp8266
  • Digispark
  • arduino
  • CAN
  • OLED
  • nextion
  • index

#TAGS

Arduino Starters Atmel AVR Bluetooth Cellular Communication Communication Display Electricity & Current Environment Sensor Gear Head Motor General Electronics Going Advance GPS Communication Home Automation Industrial Infrared Internet of Things LCD LED Liquid & Gas Sensors Medical & Health Sensors Micro DC Motor Modules Motion Detections Motors Motors & Actuators OLED Peripherals / Auxiliary Physical Monitor Sensors PIC Microcontrollers Positioning & Time Sensors Probes Proximity Sensors Raspberry Pi Robotics & Mechatronics RX/TX Radio Sensors Servos Stepper Motors STM Series TCP / IP Communication Texas Instruments Boards TFT LCD The Starters Thoughts Touch Sensors

Makers

  • Wired Developer on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Wired Developer on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Darchen on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Hichem on Wiring NodeMCU ESP8266 12E with i2C 16×2 LCD Screen
  • Robert on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring and Flashing ESP32-WROVER, ESP WROOM 32 with USB TTL UART and ESP32 Download Tool
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring Flashing / Programming ESP-32 / ESP32S with USB – TTL / UART and Integration with Arduino IDE
  • Art on Wiring the DS18S20 1-Wire Temperature Sensor with Bluetooth HC06 on Android & Microcontroller

© 2020 - 14CORE | Are licensed under a Creative Commons Attribution Non-Commercial 3.0 License.


|
Designated trademarks and brands are the property of their respective owners. Your access or use of this website
constitutes acceptance of our | Terms & Conditions| and Copyright and Trademarks Policy.




Important Cookie Information :

We use cookie to provide you the best possible experience, this site uses cookies and by continuing to use the site you agree that we can save them on your device. Cookies are small text files which are placed on your computer and which remember your preference / some details of your visit. Our cookies don’t collect any personal information. For information, please read our Privacy Statement & Cookie Policy, which also explains how to disable this option in your browser. Find out more.