14core.com

14core.com

ideas become reality

Facebooktwitterrssyoutubeinstagramflickr

Menu

  • Home
  • Starters
    • Arduino Starters
    • Raspberry Pi
    • PIC Starters
    • Intel Starters
    • STM Starters
    • Texas Instruments Boards
    • BeagleBone
    • Google IOIO
    • Peripherals / Auxiliary
    • General Electronics
  • Going Advance
    • (IOT)Internet of Things
    • Robotics & Mechatronics
    • Atmel AVR
    • PIC Microchip
    • Indus­trial Automations
      • National Intruments
      • SCADA
      • PLC / RTU
    • FPGA
      • ALTERA
      • XILINX
    • Navigation
    • STM Series
  • Downloads
    • Drivers & Software
    • Diagrams & Pin-Out
    • Code Libraries
    • Image Byte Array C-Code Generator
  • Creative Lab
  • Contact Us
  • About Us

Author: Wired Developer


Using Password Access Control on Matrix Keypad with Optocoupler Relay

These tutorial  will guide you to make  a password access control using “Keypad Membrane” connected to a Relay Module, Were just temporarily used LED for the output just to check if it is working, instead using a mechanical solenoid door

Wired Developer Arduino Starters, Atmel AVR, Going Advance, Robotics & Mechatronics 5 Comments Read more

Using Membrane Keypad/Keyboard On Arduino

These keypad it is the same like computer keyboard, but rather the pressure pads that have only outline symbol printed on a flat, flexible surface. These membrane keyboard, which work by electrical contact between the key surface under layer circuit

Wired Developer Arduino Starters No Comments Read more

Starter #17 Using RGB LED on Arduino

RGB(RED/GREEN/BLUE) LEDs Look just like a normal LED, however, inside of this LED has a 3 in 1 package, nside of the this LED it has Red, Green and Blue. This LED can be control using PWM(Pulse with Modulation) to

Wired Developer Arduino Starters, Display, LED 1 Comment Read more

Introduction to Robotic Gears, Gears Ratios and RPM

Gears are like wheels with teeth mesh together and make things turn. Gear are used to transfer motion or power from one moving part to another. A gear is rotating machine part have cut teeth, or cogs, along with another

Wired Developer Gear Head Motor, Motors & Actuators, Robotics & Mechatronics, Servos No Comments Read more

How to use Bi-Directional Bus / Logic Converter or bridge power communication

The bi-directional logic level converter is very easy to use, this board needs to be powered from two voltage source (HIGH and LOW), the high voltage let say 5v to the HV(High Voltage) pin and the LOW voltage will be

Wired Developer Electricity & Current, Physical Monitor Sensors, Positioning & Time Sensors, Proximity Sensors No Comments Read more

How to wire the DS18B20 Temperature Sensor Module on Arduino

This demo i will going to show you how to wire the DS18B20 Temperature Sensor on Arduino using library to communicate and acquire a data on DS18B20 Dallas Semiconductor Temperature Sensor. The DS18B20 is a three pin transistor like chip,

Wired Developer Arduino Starters No Comments Read more

How to use I2C Bus Interface in Arduino with Sample Code

Using I2C (I square C) in Arduino interface , I2C is a standard for connection MCU and peripherals together. I2C is sometimes referred to as 2 wire interface or TWI. All the Arduino board have at least 1 I2c socket

Wired Developer Arduino Starters, Atmel AVR, Going Advance No Comments Read more

What is BeagleBone Black and how it works?

  What is BeagleBone Black? BeagleBone Black is an embedded low-cost Linux driven Computer a powerful computer on its own in a credit card size that comes with  lots of GPIO and GPIO(PWM) interface, design for many hobbyist, engineers and

Wired Developer BeagleBone No Comments Read more

Working on Dust Particle Optical Sensor with Arduino

Sharp’s GP2Y1010U0F is an optical air quality sensor it was designed to sense dust particles. An infrared emitting diode and a photo-transistor are diagonally arrange into this device, to allow it to detect the reflected light of dust in the

Wired Developer Environment Sensor, Medical & Health Sensors, Sensors No Comments Read more

Working on PIR Motion Sensor with Arudino

This tutorial we will demonstrate how to detect motion from PIR Sensor using Arduino, ones the PIR detect a motion it will trigger the LED as the output. Electric Parts Require 1x Arduino 1x PIR Motion Sensor 1x LED 1x

Wired Developer Arduino Starters, Motion Detections, The Starters No Comments Read more

Make your Raspberry Pi as (IOT) Internet of Things Server with nRF24L01

In this tutorial i will going to demonstrate how to connect and program the nRF24L01+ Module Raspberry Pi A A+ B B+, and build a Raspberry Pi Internet of Things Server. Below are the nRF24l01 schematics and Pin Out with

Wired Developer Communication, Internet of Things, Raspberry Pi No Comments Read more

Coding a Line Finder with Arduino Module Sensors for Robotics

Below are the program sketch how to code a line following robots using Arduino, to detect Black Line & White Line when digital signal is HIGH, sensor will read black line and when digital signal is LOW, sensor will read

Wired Developer Robotics & Mechatronics No Comments Read more
Page 26 of 30« First«...10...21222324252627282930»

What’s new?

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer

Categories

  • Arduino Starters
  • Atmel AVR
  • BeagleBone
  • Bluetooth
  • Cellular Communication
  • Communication
  • Datasheets & Pin-Outs
  • Display
  • DSP Evaluation Boards
  • E Ink Module
  • Electricity & Current
  • Environment Sensor
  • Gear Head Motor
  • General Electronics
  • Going Advance
  • GPS Communication
  • Home Automation
  • Industrial
  • Infrared
  • Internet of Things
  • LabVIEW
  • LCD
  • LED
  • Liquid & Gas Sensors
  • MCU / MEMS / SOC
  • Medical & Health Sensors
  • Micro DC Motor
  • Modules
  • Motion Detections
  • Motors
  • Motors & Actuators
  • NXP Module / Boards
  • OLED
  • Peripherals / Auxiliary
  • Physical Monitor Sensors
  • PIC Microcontrollers
  • Positioning & Time Sensors
  • Power Management
  • Probes
  • Projects
  • Proximity Sensors
  • Raspberry Pi
  • RFID / NFC
  • Robotics & Mechatronics
  • RX/TX Radio
  • SCADA
  • Sensors
  • Servos
  • Stepper Motors
  • STM Series
  • TCP / IP Communication
  • Texas Instruments Boards
  • TFT LCD
  • The Starters
  • Thoughts
  • Touch Sensors
  • VFD

Recent

  • Build your Own Thermometer with ThingSpeak
  • Wiring the VISHAY VEML6030 High Accuracy Ambient Light Digital Sensor
  • Wiring the Broadcom APDS 9253 001 Digital RGB IR Light Sensor
  • Wiring The TE-HTU21D Digital Humidity Sensor
  • Wiring the TI – HDC2080 A Low-Power Driven Temperature & Humidity Digital Sensor
  • Wiring the KIONIX SPI/i2C- KX224 1053 Tri-axis Digital Accelerometer
Facebooktwitterrssyoutubeinstagramflickr

Information

  • About Us
  • Contact Us
  • Terms & Conditions
  • Privacy Policy

Popular Searches

  • ESP32
  • attiny85
  • esp8266
  • Digispark
  • arduino
  • CAN
  • OLED
  • nextion
  • index

#TAGS

Arduino Starters Atmel AVR Bluetooth Cellular Communication Communication Display Electricity & Current Environment Sensor Gear Head Motor General Electronics Going Advance GPS Communication Home Automation Industrial Infrared Internet of Things LCD LED Liquid & Gas Sensors Medical & Health Sensors Micro DC Motor Modules Motion Detections Motors Motors & Actuators OLED Peripherals / Auxiliary Physical Monitor Sensors PIC Microcontrollers Positioning & Time Sensors Probes Proximity Sensors Raspberry Pi Robotics & Mechatronics RX/TX Radio Sensors Servos Stepper Motors STM Series TCP / IP Communication Texas Instruments Boards TFT LCD The Starters Thoughts Touch Sensors

Makers

  • Wired Developer on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Wired Developer on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Darchen on Wiring the 6 Digit 7 Segment 2.4 Inch HT1621 LCD Display Module on Microcontroller
  • Hichem on Wiring NodeMCU ESP8266 12E with i2C 16×2 LCD Screen
  • Robert on nRF24l01 I2C/TWI (2 Wire Interface) Communication Shield Setup Guide
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring and Flashing ESP32-WROVER, ESP WROOM 32 with USB TTL UART and ESP32 Download Tool
  • Build your Own IOT – COVID-19 Fever Symptoms Thermometer with ThingSpeak | 14core.com on Wiring Flashing / Programming ESP-32 / ESP32S with USB – TTL / UART and Integration with Arduino IDE
  • Art on Wiring the DS18S20 1-Wire Temperature Sensor with Bluetooth HC06 on Android & Microcontroller

© 2020 - 14CORE | Are licensed under a Creative Commons Attribution Non-Commercial 3.0 License.


|
Designated trademarks and brands are the property of their respective owners. Your access or use of this website
constitutes acceptance of our | Terms & Conditions| and Copyright and Trademarks Policy.




Important Cookie Information :

We use cookie to provide you the best possible experience, this site uses cookies and by continuing to use the site you agree that we can save them on your device. Cookies are small text files which are placed on your computer and which remember your preference / some details of your visit. Our cookies don’t collect any personal information. For information, please read our Privacy Statement & Cookie Policy, which also explains how to disable this option in your browser. Find out more.